If you can't find the help you are looking for, please contact us, our technical support team will be happy to help.
BIKE MAINTENANCE & TROUBLESHOOTING
We recommend that you regularly inspect your bike and perform maintenance procedures such as lubricating and tightening moving parts and connections.
We also advice that you keep your bike at room temperature, away from moisture and dust, and that you wipe any perspiration from the machine after each use.
CONSOLE SCREEN DISPLAY
A loose connection can result in the console not displaying distance, speed, or calories, or showing no display at all. Check all connections in the front post stem to ensure the wires are connected and intact. If the problem persists, please contact us.
HAND PULSE SENSORS
Loose connections or poor contact with the hand pulse sensors can result in no reading being displayed.
Follow the instructions below:
Stop the bike and remove power from the machine and / or batteries from the computer
Clean the metal surface of the hand pulse sensors with a damp cloth
Replace the batteries and / or power
Ensure the palm of the hand is wrapping about both the top and bottom plates of the pulse sensor. Just the thumb wrapping around the bottom is not sufficient to achieve a good contact
Ensure the sensors are being held firmly, but not tight
Before obtaining a pulse reading, stop moving, remaining still will ensure the best pulse reading
If the drive belt comes off the pulleys, your bike may make a loud bang and appear to have no resistance in the pedals. The outer cover can be removed in order to investigate. If the belt is still intact it should be easy to place back on the correct path. If the belt has snapped or for further advice, please contact us.
CONNECTING THE TENSION WIRE
If the tension wire on your bike appears to be too short and can't be connected, follow the instructions below:
Set the bike to the highest level of resistance - this will move the lower section of the clip closer to the tension cable
Attach the tension cable to the lower section of the clip
Now pull the handlebar post upwards with reasonable force - this will not break the cable but will lengthen it slightly to allow the top section to be locking into position
The stabiliser with wheels should be fitted to the front of the bike, in order to assist moving the machine.
CONNECTING THE PEDALS
When screwing the pedals onto the crank, the left pedal will have a reversed thread and needs to be attached in a backwards direction.
We offer the following warranty on all adidas bikes:
Frame - 2 years
Computer - 2 years
Brake - 2 years
Plastic - 2 years
Labour (Europe) - 2 years
Labour (Rest of the world) - 2 years